In-Die Marking Units for Metal Stampings

CUMSA In-Die Marking Units

BENEFITS and FEATURES

Simple to install, these in-die marking units allow easy part identification of your metal stampings. CUMSA in-Die Marking Units are made from durable 4140 steel alloy and stainless steel for long operating life. Features of the CUMSA Marking Units are:

4 and 6 Wheel Unit Design

Traceability for Stamped Parts

Simple In-Die Installation

Easily Adjust Wheels In The Die

250,000 Plus Strokes Reported

Special Characters are Available

In-Die Installation Specifications

Follow the drawing below for size selection, proper mounting and clearances.

CUMSA Marking Unit Installation

Interchangeable Marking Wheel

Wheels are easy to replace and interchange for both 4 and 6 wheel units. Change marking wheels with a simple screwdriver! Hardened D2 steel alloy wheel construction allows for long marking unit impression cycles for your metal stampings.

CUMSA Marking Unit Wheel

Interchangeable Wheel Details

Use drawing below for ordering replacement marking wheels and for character specifications.

CUMSA Marking Wheel Specifications

home • products • publications • motion • sales • email

Additional Information

A complete and downloadable CUMSA In-Die Marking Unit brochure is available in our Publications section on our website.
Shopping for Superior die sets are easy! Visit our online shopping site: http://www.shopsupdie.com

Locate Us on the Map
Oak Creek, WI 900 West Drexel Ave. Oak Creek, WI 53154 Toll Free (800) 558-6040 Phone (414) 764-4900 Fax (800) 657-0855